This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
scalability_with_autosubmit [2017/07/03 09:08] dmanuben |
scalability_with_autosubmit [2017/07/03 09:34] adegimel [Autosubmit database setup and install] |
||
---|---|---|---|
Line 17: | Line 17: | ||
To create an isolated environment and different database you have to follow next steps: | To create an isolated environment and different database you have to follow next steps: | ||
- | 1- Create a directory in any place you like (e.g. your home dir): | + | 1- Create a new directory in any place you like (e.g. your $HOME dir): |
- | mkdir ~/autosubmit_performance | + | mkdir ~/performance_autosubmit |
- | 2- Edit .autosubmitrc file, and change DATABASE, LOCAL and CONF paths to make them point to the directory created above: | + | 2- Edit .autosubmitrc file (located by default in your $HOME dir), and change DATABASE, LOCAL and CONF paths to make them point to the directory created above. You need to replace any path pointing to / |
+ | |||
+ | If the file is not present, you can create it and fill in with the contents below, but changing the user name with yours: | ||
vi ~/ | vi ~/ | ||
Line 40: | Line 42: | ||
autosubmit install | autosubmit install | ||
+ | Then it is ready to be used. | ||