clause

Sinfo output format of "%P" now prints "*" after default partition even if
no field width is specified (previously included "*" only if no field width
was specified. Added output format of "%R" to print partition name only
without identifying the default partition with "*").

fatal when no from the controller.

Show this HTML in a new window?
There is a minor problem with the display of partition names in
"sinfo".  Without options, the partition name field displays a
asterisk "*" at the end of the name of the Default partition.  If you
specify a formatting option which contains the %P field specifier with
a width option (e.g., sinfo -o %8P) the asterisk also is appended to
the default partition name.  With no width option, the "%P" displays
the name based on the full length of the name string, however, no "*"
is appended on the default partition name.

The attached patch for version 2.4.0-pre4 corrects the problem so that
the "*" is correctly appended when %P with no width specifier is
used. The patch will also apply to version 2.3.4.

  -Don Albert-

If a node or partition name is duplicated in slurm.conf, then log
it using error() and ignore the duplicate record. Update documentation
to be more clear

starts.

SLURM wouldn't create another overlapping block on a job requesting that
size of block.

Previously the code would come up with how much memory a PE should have
instead of the memory a node should have.

Mark Nelson.

incorrectly set in the job.

that go into error the block is freed.

start a job on the block.  Before there was room for a block boot to fail
if another thread was trying to free it while trying to start a job.

it is happening, just to keep tabs correctly on the matter.

dynamic mode.

job_ptr.

job on a block and it isn't being configured or booted we fixed a double
free issue.