where signal is recieved after having allocated nodes but before
   real signal handlers are installed.

   to close, do not wait for job indefinitely.

 string (this is not needed).

   failed (presumably due to unkillable processes)
 o retry failed JOB_KILL rpcs

   rpc.

Default output changed: Remove PRIO, TIME_LIMIT, Add TIME_USED #NODES
Long output changed: Remove PRIO, START_TIME, END_TIME. Add TIME_USED, #NODES
Step output changed: Remove START_TIME, Add TIME_USED
Output line "No jobs found in system" removed.

error).

too low configuration.

Formerly set state to DRAINING instead of DRAINED.

the --long option is specified.

RPC in agent.

  information

 o add calls to interconnect_node_init/fini() in slurmd.
 o move interconnect_postfini() above wait_for_io()

   waiting for processes once slurmctld closes the connection.

   is not inadvertently killed.
 o slight changed in slurmd "task %d exited ..." debug message

   interconnect_node_fini() to allow for interconnect specific node
   initializations.
 o Elan interconnect module now runs the network error resolver thread
   (requires /etc/elanhosts config file)

   instead of just kill_wait seconds because slurmd sleeps for kill_wait
   seconds, so therefore slurmctld would never recv a reply.

 o Do not terminate job if job is already terminating, just exit launch thd.

   has been no IO activity since job ended/failed/etc.