previous 20 minute time limit.  The previous behavior would fail for
large files 20 minutes into the transfer.

Close the batch job's environment file when it contains no data to avoid
leaking file descriptors.

to operate the same way salloc or sbatch did and assign a task per cpu
by default instead of task per node.

correctly.  Before the errno wasn't being checked correctly

to operate the same way salloc or sbatch did and assign a task per cpu
by default instead of task per node.

correctly.  Before the errno wasn't being checked correctly

This patch adds logic to work around advanced reservations better.

Change node_req field in struct job_resources from 8 to 32 bits so we can
run more than 256 jobs per node.

correctly as of IBM driver V1R1M1 efix 008.

configured correctly.

current or in the past.

from Mark Nelson

Using the syscalls directly rather than calling bin/(u)mount via
system() avoids a few fork + exec calls, and provides better error
handling if something goes wrong.

Users of this functionality are also updated to use slurm_strerror in
order to provide a more informative error message.

The mount and umount syscalls are Linux-specific, but so are cgroups
so no portability is lost.

Using the syscalls directly rather than calling bin/(u)mount via
system() avoids a few fork + exec calls, and provides better error
handling if something goes wrong.

Users of this functionality are also updated to use slurm_strerror in
order to provide a more informative error message.

The mount and umount syscalls are Linux-specific, but so are cgroups
so no portability is lost.

Using the syscalls directly rather than calling bin/(u)mount via
system() avoids a few fork + exec calls, and provides better error
handling if something goes wrong.

Users of this functionality are also updated to use slurm_strerror in
order to provide a more informative error message.

The mount and umount syscalls are Linux-specific, but so are cgroups
so no portability is lost.

    the current plugin has been loaded when using runjob_mux_refresh_config

I would like to make two changes to this:

1) since the reservation name can easily exceed 9 characters, I would like the field to be however large it needs to be without truncating the name. I did this by looking at the names then setting the field size to that width.

2) The other headers are in capitals, so I changed

 ResName    State       StartTime             EndTime           Duration  Nodelist

to

RESV_NAME        STATE           START_TIME            END_TIME     DURATION  NODELIST

Correct parsing of srun/sbatch input/output/error file names so that only
the name "none" is mapped to /dev/null and not any file name starting
with "none" (e.g. "none.o"). This fixes bug #98.

Gres: If a gres has a count of one and an associated file then when doing
a reconfiguration, the node's bitmap was not cleared resulting in an
underflow upon job termination or removal from scheduling matrix by the
backfill scheduler.

Cray and BlueGene - Do not treat lack of usable front-end nodes when
slurmctld deamon starts as a fatal error. Also preserve correct front-end
node for jobs when there is more than one front-end node and the slurmctld
daemon restarts.

while it is attempting to free underlying hardware is marked in error
making small blocks overlapping with the freeing block.  This only
applies to dynamic layout mode.

is always set when sending or receiving a message.

than 1 midplane but not the entire allocation.

multi midplane block allocation.

where other blocks on an overlapping midplane are running jobs.