block happens correctly now.

Add the ability to update a node's NodeAddr and NodeHostName with scontrol.
Also enable setting a node's state to "future" using scontrol.

Major re-write of the CPU Management User and Administrator Guide (web
page) by Martin Perry, Bull.

If a job can not run due to QOS or association limits, then do not cancel
the job, but leave it pending in a system held state (priority = 1). The
job will run when its limits or the QOS/association limits change. Based
upon a patch by Phil Ekcert (LLNL).

booted block. -- pass 1, more work needs to be done.

Prevent associations from being delete if it has any jobs in running,
pending or suspended state. Previous code prevented this only for running
jobs.

Fix bugs in sched/backfill with respect to QOS reservation support and job
time limits. Patch from Alejandro Lucero Palau (Barcelona Supercomputer Center).

Fix to GRES allocation logic when resources are associated with specific
CPUs on a node. Patch from Steve Trofinoff, CSCS.

(i.e. 1-9,0 instead of 0-9).  The bug would cause 'sacct -N nodename' to
not give correct results on these systems.

is in an error state, won't deny jobs.

restarts of the slurmctld.

admin sets the state to error.

Change default value of StateSaveLocation configuration parameter from
/tmp to /var/spool, where the files are less likely to be purged.

Modify slurmdbd.conf parsing to accept DebugLevel strings (quiet, fatal,
info, etc.) in addition to numeric values. The parsing of slurm.conf was
modified in the same fashion for SlurmctldDebug and SlurmdDebug values.
The output of sview and "scontrol show config" was also modified to report
those values as strings rather than numeric values.

Do not treat the absence of a gres.conf file as a fatal error on systems
configured with GRES, but set GRES counts to zero. These counts can be
Counts can be altered by node_config_load() in the gres plugin.

Add the ability to reboot all compute nodes after they become idle. The
RebootProgram configuration parameter must be set and an authorized user
must execute the command "scontrol reboot_nodes". Patch from Andriy
Grytsenko (Massive Solutions Limited).

Interpret a reservation with Nodes=ALL and a Partition specification as
reserving all nodes within the specified partition rather than all nodes
on the system. Based upon patch by Phil Eckert (LLNL).

An a flag record to event triggers and add support for a flag value of
"PERM" for permanent triggers, triggers which are only removed when the
slurmctld daemon is cold-started or the trigger is explicitly removed.

Many cosmetic modifications to eliminate warning message from GCC version
4.6 compiler, mostly due to unused variables.

Permit administrator to change a job's QOS to any value without validating
the job's owner has permission to use that QOS. Based upon patch by Phil
Eckert (LLNL).

Modify advance reservation to accept multiple specific block sizes rather
than a single node count. This is very important for BlueGene systems.

Modify srun's SIGINT handling logic timer (two SIGINTs within one second) to
be based microsecond rather than second timer.

Avoid clearing a job's reason from JobHeldAdmin or JobHeldUser when it is
otherwise updated using scontrol or sview commands. Patch based upon work
by Phil Eckert (LLNL).

Do not remove the backup slurmctld's pid file when it assumes control, only
when it actually shuts down. Patch from Andriy Grytsenko (Massive Solutions
Limited).

variable wasn't initialized in the job structure making it so that job
wouldn't run.

(i.e. BP List -> MidplaneList).

algorithm.  The improves timing in the worst cases and simplifies the code
greatly.

conn_types in a block definition.

allow them on Q systems.