Add salloc/sbatch/srun option --use-min-nodes to prefer smaller node counts
    when a range of node counts is specified (e.g. "-N 2-4").
bug 2996

Switch a few SLURM mentions for Slurm as well.

It was out of alphabetic order before (e.g. after --power).

Add salloc/sbatch/srun --priority option of "TOP" to set job priority to
    the highest possible value. This option is only available to Slurm operators
    and administrators.
bug 3115

The problem reported is just a configuration warning and not an
 error. Also change the test from ">=" to ">".
bug 3086

This patch finally resolves absolute/relative CPU mapping for nodes
where the NUMA (or sockets) have different core counts (e.g. KNL SNC4).

bug 3090

Make sure no attempt is made to schedule a requeued job until all steps are
    cleaned (Node Health Check completes for all steps on a Cray).
bug 3082

Otherwise limit is checking the node count against the midplane count.

Bug 3049.

Check if node names are contiguous with respect to the node list
assigned to the partition, rather than just monotonically increasing.

Bug 3006.

xcgroup_delete will print a log message if there is a problem.

Bugs 2681 and 2703

Conflicts:
	NEWS

license of a certain type.

node_features/knl_cray plugin: Increase default CapmcTimeout parameter from
    10 to 60 seconds.
bug 3100

capmc_suspend/resume - If a request modify NUMA or MCDRAM state on a set of
    nodes or reboot a set of nodes fails then just requeue the job and abort the
    entire operation rather than trying to operate on individual nodes.
bug 3100

Allow a node's PowerUp state flag to be cleared using update_node RPC.
bug 3100

When powering up a node to change it's state (e.g. KNL NUMA or MCDRAM mode)
    then pass to the ResumeProgram the job ID assigned to the nodes in the
    SLURM_JOB_ID environment variable.
bug 3100

Don't log error for job end_time being zero if node health check is still
    running.
bug 3053

Restore ability to manually power down nodes, broken in 15.08.12
in commit b4904661

The patch introduced in commit b4904661 (not powering down dead node) has a bad side effect.  Adding the "(node_ptr->last_idle != 0)" condition prevents from powering down nodes with the following command:

scontrol update nodename=nX state=power_down

because the state update function relies on zeroing the "last_idle" variable when a power_down is requested (see src/slurmctld/node_mgr.c, line 1589).

Reverting this commit should solve the problem...but I let you decide...

Didier GAZEN

bug 3093

node_features/knl_cray: If a node is rebooted outside of Slurm's direction,
    update it's active features with current MCDRAM and NUMA mode information.
bug 3071

Fix race condition that could result in MCDRAM state information coming
  from capmc rather than cnselect (used state for next boot rather than
  latest boot).
bug 3080

No functional change, just silencing the warning message in this instance.

Bug 3079.

Fix some whitespace on line endings while here.

Bug 3073.