Change default value of StateSaveLocation configuration parameter from
/tmp to /var/spool, where the files are less likely to be purged.

Modify slurmdbd.conf parsing to accept DebugLevel strings (quiet, fatal,
info, etc.) in addition to numeric values. The parsing of slurm.conf was
modified in the same fashion for SlurmctldDebug and SlurmdDebug values.
The output of sview and "scontrol show config" was also modified to report
those values as strings rather than numeric values.

Conflicts:
	doc/man/man5/slurm.conf.5

Advise use of the logrotate tool in order to avoid SLURM log files
from growing too large. Patch from Rod Shultz, Bull.

Do not treat the absence of a gres.conf file as a fatal error on systems
configured with GRES, but set GRES counts to zero. These counts can be
Counts can be altered by node_config_load() in the gres plugin.

If KillOnBadExit is configured to 1 and an srun task exits with a
non-zero exit code then report the correct termination reason
NonZeroExitCode rather than Cancelled.

Add the ability to reboot all compute nodes after they become idle. The
RebootProgram configuration parameter must be set and an authorized user
must execute the command "scontrol reboot_nodes". Patch from Andriy
Grytsenko (Massive Solutions Limited).

Note that a job's size factor in setting priority is based upon node
or CPU count.

Add the ability to read the slurm.conf file across a network using
the accounting_storage plugin. The accounting_storage/slurmdbd plugin
does require modification for this functionality to fully operate.
Patch from Andriy Grytsenko (Massive Solutions Limited).

The slurmctld code that processes job notify messages unecessarily
restricts these messages to be from the slurm user or root. This
patch allows users to send notifications to their own jobs.

The slurmctld code that processes job notify messages unecessarily
restricts these messages to be from the slurm user or root. This
patch allows users to send notifications to their own jobs.

Interpret a reservation with Nodes=ALL and a Partition specification as
reserving all nodes within the specified partition rather than all nodes
on the system. Based upon patch by Phil Eckert (LLNL).

Change the event trigger data structure for slightly improved performance.

An a flag record to event triggers and add support for a flag value of
"PERM" for permanent triggers, triggers which are only removed when the
slurmctld daemon is cold-started or the trigger is explicitly removed.

Many cosmetic modifications to eliminate warning message from GCC version
4.6 compiler, mostly due to unused variables.

without putting a block in error state.

Permit administrator to change a job's QOS to any value without validating
the job's owner has permission to use that QOS. Based upon patch by Phil
Eckert (LLNL).

Update tests as appropriate for change in output of many commands.
BP_LIST or BP_List change to MIDPLANELIST or MidplaneList.

Modify advance reservation to accept multiple specific block sizes rather
than a single node count. This is very important for BlueGene systems.

Modify srun's SIGINT handling logic timer (two SIGINTs within one second) to
be based microsecond rather than second timer.

midplane that has that cable as it's 'out' cable.  Since the node isn't
really down there isn't really a better place to mark a note about it.

structure.