the error happened.

Correct preservation of job ID. This effects emulation mode only.
bug 2113

Added burst_buffer.conf flag parameter of "TeardownFailure" which will
    teardown and remove a burst buffer after failed stage-in or stage-out.
    By default, the buffer will be preserved for analysis and manual teardown.
bug 2116

If a stage-out fails, Slurm leaves the burst buffer in place and
  logs something like
  "error: bb_set_use_time: job 98 with allocated burst buffers not found"
  every minute thereafer.
  This changes the logic to only log the event one time.
bug 2112

This is a revision to commit e21b666c
which did not fix the problem for all configurations.
bug 2086

Bug 2106

What was happening was the calculation wasn't happening for memory
or nodes, just cpus and gres.

bug 2086

Job needs exit code of zero for COMPLETED state.

bug 2093

This reverts commit 5bf40e44.

pre-increment.

The "dw_wlm_cli paths" command returns an error if no #DW options.

commit:508f866e

Conflicts:
	etc/slurmd.service.in

Bug 2095

Increase dead socket timeout from 5 to 10 minutes before purge
Log connect failure as "debug" rather than "error" as it can be
  generated due to a race condition at step termination.

Previous logic would not check on remaining persistent burst buffer
space needed for a job.

This might be related to bug 2028

Add logic to call the "setup" function.

in an hour counting multiple times.

if this was the case we could get bug 2068
http://bugs.schedmd.com/show_bug.cgi?id=2068 to happen.

This will be fixed in a future commit.

Return permission denied if regular user tries to release job held by an
    administrator.
bug 2087

Previous logic ignored lack of memory, file descriptors, buffers, etc.
bug 2028