- 21 Feb, 2018 5 commits
-
-
Danny Auble authored
Bug 4698.
-
Morris Jette authored
-
Dominik Bartkiewicz authored
Bug 4809.
-
Dominik Bartkiewicz authored
NEWS entry also applies to prior 31667d5d. Bug 4809.
-
Dominik Bartkiewicz authored
Fixes problems restoring: - Alternate - DefMemPerCPU - MaxCPUsPerNode - MaxMemPerNode - OverTimeLimit Also move AllowNodes, DefaultTime, and GraceTime into alphabetical order. Bug 4809.
-
- 20 Feb, 2018 7 commits
-
-
Marshall Garey authored
Bug 4636
-
Brian Christiansen authored
Bug 4716
-
Brian Christiansen authored
Bug 4716
-
Felip Moll authored
In perl tools, fix for regexp that caused extra incorrectly shown results. Bug 4766
-
Danny Auble authored
-
Danny Auble authored
requesting any tasks. Bug 4730
-
Morris Jette authored
wait to retry or not. I discovered this bug regression testing. Some similar situations will result in srun continuously issuing step create requests and the launch_common_create_job_step() function not sleeping between RPCs. Basically launch_common_create_job_step() sleeps for some error codes and srun retries the step create on some error codes. The problem is that those error codes do not match in both places, resulting in constant retries without sleeps. This situation is very likely with job preemption combined with salloc, but other conditions can trigger the same event. The following errno will all trigger this situation: EAGAIN, ESLURM_DISABLED, ESLURM_POWER_NOT_AVAIL, ESLURM_POWER_RESERVED, ESLURM_PROLOG_RUNNING, ESLURM_INTERCONNECT_BUSY. Bug 4786
-
- 16 Feb, 2018 3 commits
-
-
Brian Christiansen authored
Bug 4772
-
Brian Christiansen authored
Was checking time ranges against a bad cast'ed variable. And MaxQueryTimeRange was being stored as minutes and was being compared against the difference of two time_t's -- which produces seconds. Bug 4772
-
Dominik Bartkiewicz authored
was matching more than expected. Bug 4789
-
- 15 Feb, 2018 3 commits
-
-
Doug Jacobsen authored
Fixes issue with bf_min_prio_reserve not being respected, leading to significantly impacted backfill performance. Bug 4760.
-
Tim Wickberg authored
-
Morris Jette authored
Log that support for the ChosLoc configuration parameter will end in Slurm version 18.08. Bug 4791
-
- 14 Feb, 2018 2 commits
-
-
Tim Wickberg authored
-
Tim Wickberg authored
And would prevent transmission of a file. Bug 4787.
-
- 13 Feb, 2018 5 commits
-
-
Morris Jette authored
-
Danny Auble authored
Bug 4736 Bug 4784
-
Morris Jette authored
Partial write can happen under high system load, leading to step termination when finishing the write would let the step launch properly instead. Fix suggested by Matthieu Hautreux. Bug 4778.
-
Felip Moll authored
Add a privilege check for when an unprivileged user tries to modify a resource. Min level set to Operator. Bug 4735.
-
Felip Moll authored
Bug 4747.
-
- 12 Feb, 2018 3 commits
-
-
Isaac Hartung authored
Default --list_reasons format is "%20E %9u %19H %N" Bug 4762
-
Tim Wickberg authored
-
Felip Moll authored
Fixes some issues around differences in lua package naming. Bug 4568.
-
- 09 Feb, 2018 2 commits
-
-
Tim Wickberg authored
-
Tim Wickberg authored
Reformat comment blocks to respect 80-columns and /* comment */ format conventions.
-
- 08 Feb, 2018 3 commits
-
-
Alejandro Sanchez authored
Bug 4681.
-
Dominik Bartkiewicz authored
Bug 4709.
-
Dominik Bartkiewicz authored
Bug 4646
-
- 07 Feb, 2018 7 commits
-
-
Morris Jette authored
-
Morris Jette authored
Report all SPANK validations that fail, not just the first one Log local and remote plugstack.conf file checksum to identify possible file system delay issues bug 4694
-
Alejandro Sanchez authored
Previously it was taking the MIN, without respecting the order. Also add a note to the resource_limits.html page to clarify the exception for Max[Wall|Time] and/or [Max|Min]Nodes limits, where the default is that the Partition is the king with regards of precedence, unless the respective job's QOS flags Partition[Min|Max|Time]Limit are set. Bug 4681.
-
Danny Auble authored
This prevents a hard-to-diagnose issue where slurmstepd may fail to start due to a missing library. This now ensures slurmd will fail, and keep the node down until the library issue can be fixed. Bug 4645, 4644.
-
Danny Auble authored
fatal() calls exit(1) which precludes getting a backtrace. That's fine on configuration issues and other types of problem, but for hitting "impossible" edge cases getting a core dump may be the only way to isolate the issue. Adding to 17.11 so we can easily provide diagnostic patches without needing users to back-port this implementation. Further use will come in 18.08. Bug 4599.
-
Tim Wickberg authored
-
Tim Wickberg authored
-