If a job can not run due to QOS or association limits, then do not cancel
the job, but leave it pending in a system held state (priority = 1). The
job will run when its limits or the QOS/association limits change. Based
upon a patch by Phil Ekcert (LLNL).

booted block. -- pass 1, more work needs to be done.

Remove unused function acct_policy_node_usable() from src/slurmctld/acct_policy.c

Prevent associations from being delete if it has any jobs in running,
pending or suspended state. Previous code prevented this only for running
jobs.

PluginDir is a path. It shouldn't be an error to have duplicate
plugins in your path. Plus, the error is not helpful because it
doesn't specify which path is not being loaded. Therefore, just
remove the error and load the first plugin in the path as expected.

Fix bugs in sched/backfill with respect to QOS reservation support and job
time limits. Patch from Alejandro Lucero Palau (Barcelona Supercomputer Center).

Fix to GRES allocation logic when resources are associated with specific
CPUs on a node. Patch from Steve Trofinoff, CSCS.

system, accounting will be notified.

(i.e. 1-9,0 instead of 0-9).  The bug would cause 'sacct -N nodename' to
not give correct results on these systems.

is in an error state, won't deny jobs.

restarts of the slurmctld.

admin sets the state to error.

Change default value of StateSaveLocation configuration parameter from
/tmp to /var/spool, where the files are less likely to be purged.

Modify slurmdbd.conf parsing to accept DebugLevel strings (quiet, fatal,
info, etc.) in addition to numeric values. The parsing of slurm.conf was
modified in the same fashion for SlurmctldDebug and SlurmdDebug values.
The output of sview and "scontrol show config" was also modified to report
those values as strings rather than numeric values.

Conflicts:
	doc/man/man5/slurm.conf.5

Advise use of the logrotate tool in order to avoid SLURM log files
from growing too large. Patch from Rod Shultz, Bull.

Do not treat the absence of a gres.conf file as a fatal error on systems
configured with GRES, but set GRES counts to zero. These counts can be
Counts can be altered by node_config_load() in the gres plugin.